Precautions for installation of
cable waterproof connector
Choose appropriate joint materials according to the type and specifications of the cable joints. Nowadays, the quality of cable joint materials is also uneven. However, in order to ensure the quality of cable joints, it is recommended not to be cheap, and it is best to choose the materials of reliable cable joint manufacturers.
It is best not to choose rainy days when connecting the cable, because water in the cable will seriously affect the service life of the cable, and even short-circuit accidents may occur in serious cases.
Be sure to read the manufacturer's product manual carefully before making the
cable waterproof connector. This is particularly important for cables of 10kV and above. Think about all the processes before doing it. For terminal connectors of single-core armored cables above 10kV, remember that only one end of the steel strip can be grounded.
The copper pipe should not be pressed too hard, as long as it is crimped in place, the copper end face after crimping is bound to have many raised points, this must be flattened with a file, and no burrs should be left.
When using the heat-shrinkable cable joint to blow the torch, pay attention to the torch moving back and forth, and not just keep blowing the torch in one direction.
The size of the cold-shrinkable cable connector must be strictly in accordance with the drawings, especially when pulling out the support in the reserved tube, be more careful.
